Introduction and daily maintenance of cold-formed tile press
The tile press equipment can also be called cold roll forming, that is, on a row of serial forming mills, the metal plate and the metal strip are connected to bend them in sequence, and the flat plate is processed into the plasticity of the required cross-sectional shape. Processing method. Roll forming (color steel tile equipment) has been used for bicycle rims, umbrella skeleton manufacturing, etc.
How to use the tile press to be able to use it for a long time, the first thing to do is to remember the maintenance manual of the tile press. What should be done every day is good for the tile press, we should stick to it every day.
First of all, the surface of the tile press should be cleaned. The stamping process of the upper die of the machine: the motor drives the input shaft through the pulley, drives the upper shaft through the pinion gear and the large gear, and drives the sliding seat with the upper die through a set of cam mechanism. Move up and down to achieve tile pressing.
The indexing of the worktable is achieved by the gear set installed on the end of the upper shaft, the transmission pin gear, and the sheave installed on the hexagonal runner shaft to realize the indexing positioning. The return cam, which is installed on the same shaft and conjugated with the pressing cam, realizes the precise positioning of the lower die at the working position through the positioning rod and the positioning plate. In the left and right sides of the chassis, there are lubricating pumps installed. When the machine is working, the oil pipes deliver lubricating oil to the friction moving parts. Those who understand the structure, performance and operating procedures of the machine are not allowed to start the machine.
It is strictly forbidden to work beyond the minimum closing height, that is, the minimum distance from the bottom of the upper sliding box to each side of the work is 290mm. The height after the upper and lower molds is required to be added. The thickness of the upper and lower backing plates plus the thickness of the tile is not allowed to exceed 290mm. It should be designed according to this requirement to avoid machine tool accidents.
Always pay attention to observe the height of the lubricating oil in the sliding box and both sides of the body. The equipment should be wiped frequently and kept clean, and no mud and water should be allowed.