Safety operation requirements of wire drawing machine
1. The operator needs to wear gloves to remember the operation to prevent burns and affect the quality of the product during the operation.
2. Operation before the start of the machine to check the drawing machine air supply line for air leakage, and send the air filter in the accumulation of water.
3. To correctly install the drawing sand belt, the direction of the arrow on the inside of the drawing sand belt should be consistent with the direction of the arrow on the drawing roller.
4. Carefully check whether the upper and lower bearing blocks and lifting screw lubrication is good, and make sure that no one is on the front side of the material before starting the machine.
5. After the start of the wire drawing machine to observe whether the sand belt bye service in the normal range, if there are abnormalities should immediately shut down the machine for adjustment.
6. It is strictly forbidden to start the wire drawing machine and dust collection fan at the same time, it is strictly forbidden to start the machine after the operator left the work station.
7. In the two people working at the same time, wire drawing machine equipment behind the staff can not target the wire drawing machine outlet, so as to avoid the abolition of wire injury events.
8. The pressure of the wire drawing machine should be kept moderate, in general the pressure gauge should now be between 35-37, can not exceed the red line, so as not to cause the failure of the wire drawing machine equipment.
9. In the normal operation of the wire drawing machine equipment can not adjust the air pressure, so as not to cause the sand belt out of control phenomenon.
10. In the wire drawing machine equipment anomalies should be immediately shut down to stop the operation, inspection, so as not to cause greater accidents.
11. Wire drawing machine equipment in the process of maintenance should be cut off the power supply, and show a warning sign is strictly prohibited to operate, so as not to cause accidents.
12. Wire drawing machine equipment should be turned off when not in use for a long time the total power supply and compressed air to ensure the safety of the wire drawing machine equipment.