Water tank type wire drawing machine brief introduction
Compared with other similar equipment, the special place of the water tank wire drawing machine is that when the wire is in the drawing process, there is a different degree of relative sliding between the coil and the wire. And during the work, the steel wire, drum, drawing die, etc. involved are soaked in the cooling lubricant, or are sprayed by the cooling lubricant. Water tank wire drawing machine (also known as sliding type multiple wire drawing machine) has the characteristics of reverse tension drawing, which is simple in structure, compact, covers less land, easy to operate, high drawing speed, good cooling conditions, long die service life, environmental protection, no dust, finished steel wire surface clean without torsion.
Water tank wire drawing machine equipment operating procedures:
(1) Before the water tank wire drawing machine equipment is turned on, it is necessary to check the equipment air pressure, oil level, and the fastening and lubrication of the I-wheel winding machine, whether there is a problem, and whether the safety protection device of the equipment is intact and can work normally.
(2) Before rolling, it is necessary to check whether the incoming material meets the specified requirements, whether the quality is qualified, and whether the mold is suitable.
(3) Open the water valve, fill the water tank with soap, and then close the water inlet valve.
(4) Before starting the I-wheel take-up machine, it is necessary to check whether its air pressure is normal, and after the air pressure is normal, we can install the I-wheel.
(5) During the operation of the water tank wire drawing machine equipment, if there is an anomaly, it should be stopped immediately, and then repaired and eliminated.